 Home Vibration Isolation Tables Assembly Instructions
Vibration Isolation Tables - Assembly Instructions
Table frame with four Series 320 Vibration Isolation Bearings (bearings) bolted to the cross bars beneath the tabletop surface.
A box that contains: (1) A 15.00” x 25.00” platform (the “Isolated Platform” or “Platform”); (2) DVD/CD containing video setup instructions (for use in the event these written instructions are not clear). (See Pic. No. 1 for photo of table frame and Platform sitting on the side of the table.) |
- Remove table frame and place it where it is to be located. The table was leveled at the Vistek factory so no further leveling should be required. Remove the platform from the box.
- Remove the tape that holds the bearings in place.
- The bearings are mounted to crossbars as part of a height adjustment assembly. When the table is shipped, the assembly is adjusted to the lowest height. The assembly is adjusted by turning the round, knurled portion.
- Place the Isolated Platform (weighs 48 Lbs./22 Kg) on top of the bearings with the steel side facing down. Slide the Platform into place as far as possible and then lift the Platform into position by placing a hand on the underside of the Platform. (See Pic. Nos. 2 & 3.) Center the Platform in the hole in the tabletop hole so that there is approximately 3/8” gap on all sides of the Platform between the Platform and the tabletop.
- Place the instrument on the Platform. Placing the instrument on the Platform deflects the bearings. Check to see whether the top of the Platform is flush with the tabletop and whether the four bearings have deflected the same amount. If one or more bearings have deflected more or less than another, then the Platform will not be level. The height of each bearing and thus of the Platform can be adjusted by turning the bearing leveler assembly. (Pic. No. 4) The Platform can be brought to a position that is level with the tabletop.
|
|
